Roll Grinder

Summary Job Description: Responsible for final finishes running machine.

This involves tasks related to set-up, machine operation, and disposing of chips as required.

• Receive metal rolls from machine area-a jib crane can be used to lift heavier items.
• Check prints for specific job.
• Parts placed and measurements taken and tool marked prior to running job.
• Need a forward reach of 32”.
• Gripping of parts and tools.
• May need to utilize drivers to operate the machine-can weigh up to 90#.
• Change out bearings as needed.
• Must monitor machine operation carefully due to close tolerance of machine operation-final finishes on neck and barrel.
• Trunk flexion and twisting.
• May utilize stool for sitting if needed to observe and monitor machine while running.
• Walk back and forth to monitor machine.
• Visual inspection of part.

• The chips on this machine need be shoveled into pit.
• Oil/water mix with -soda ash.
• Check machine for maintenance: check fluids, etc.
• Complete time sheet per job: materials and time noted.
• Keep area clean, sweep, pick up debris, etc.

Note: This job description is not intended to be all-inclusive.

The employee may be required to perform other duties as assigned.

If you meet the requirements above and are interested in joining our team as a Laborer, please apply with your updated resume.

We look forward to reviewing your application!

Shift: 8 hours regular shifts and 12 hours over-time shifts.

Breaks: 30 minute lunch.

Flooring: Cement, wooden platforms, grates, rubber mats.

Environment: Machine shop environment.

Need to be careful with other employees while moving overhead cranes in the vicinity.